Saturday, July 4, 2015

Minecraft Creeper - Part II and III with Assembly

This is a continuation of the Minecraft Creeper project, with the printing of the body and the clip, which joins the head and body together.

Overall the final two prints came out decent, however there was warping of the body near the legs.  The last and final "oops" moment, was while I was putting the Minecraft Creeper together, and I broke the clip, while inserting it into the head.

In hindsight, I should have examined the body and head closely and noticed there were a small "cross beam" inside each chamber, to which the clip notches fit perfect.  My biggest tip to you, the reader, is to carefully examine this as well, so your 3D printed Minecraft Creeper comes out perfectly.

Below are the time lapse videos of both the body and the clip, along with final assembly (where you can see my mistake).

Part II - Printing the body:

















Part III - Printing the clip, with Assembly:

As always, thank you very much for watching my YouTube content.  Please like, share and subscribe for more 3D printed videos!